I created this jig holder that clips on to the sx pro dongle to keep them together. I was afraid I would end up loosing the jig so I thought keeping it clipped on to the dongle was a good idea.
It took about 30mins to print and works great. The piece is thin enough so the sx pro still connects all the way in to switch even with the holder clipped on.
I would post pictures if I could.
Check out the part here thingiverse . com/thing:3001488
Spoiler
Continue reading...
It took about 30mins to print and works great. The piece is thin enough so the sx pro still connects all the way in to switch even with the holder clipped on.
I would post pictures if I could.
Check out the part here thingiverse . com/thing:3001488
Spoiler
Continue reading...