RSS Switch OLED – eMMC init fails after I knocked off the CMD (A point) resistor and the cap next to it. Wire-mounted 4.7k, still failing. Help?

[GBATEMP]

I was installing a picofly chip on my Switch OLED and the CMD (A point) resistor and the capacitor beside it came off. The pads of the resistor are off.


What I’ve done:

• Cleaned the area and checked the points with a multimeter in diode mode (battery out). CLK and DAT0 read .450 each. The resistor pads read .450 and .250 before I touched them. The capacitor pads read 0 and .450 (one side to ground).
• Scraped a long strip of solder mask off a trace by mistake (this was all done by...

Read more

Continue reading...