As my name suggest, am I noob?
I hold down power + volume up , and my switch normally boot, each time.
First, I tried the paper clip method and was failing. I switched to a 3d printed jig and still failed. I switched to hardware mode (I soldered the two pins in my joycon - Good solder joint, iv'e been soldering stuff for age) still failing!
Am I missing something? I'm lost!
Continue reading...
I hold down power + volume up , and my switch normally boot, each time.
First, I tried the paper clip method and was failing. I switched to a 3d printed jig and still failed. I switched to hardware mode (I soldered the two pins in my joycon - Good solder joint, iv'e been soldering stuff for age) still failing!
Am I missing something? I'm lost!
Continue reading...