RSS P13usb pad ripped off, need help with tracing

[de9ed]

Hey guys, I have recently tried to replace p13usb since it's the only short on the board (i was getting 0.2 Amp charging then dead). I have accidentally ripped off the pads ( Circled in Red), Is there anywhere I can connect back the trace with a jumper wire? I have also knocked out one of the resistors on the way( Circled in Blue) ( i think its the 100k ohm 0201 ) Thanks

For the bottom red circle, can I connect that to the left side of the missing resistor

P.s. can some one link me the...

P13usb pad ripped off, need help with tracing

Continue reading...