I bought this switch used, and someone tried to fix it (there are minor scratches on the board, probably from tweezers, but nothing dangerous).
Touch controller SDA&SCL are 0v when the switch is turned on, not pulled to 0 ohm after turning off.
The right joycon charges, but wont register when I slide it on.
Is there anything common in these faults? Is there anything else to blame than the Tegra? Resistors around the connectors are OK.
Continue reading...
Touch controller SDA&SCL are 0v when the switch is turned on, not pulled to 0 ohm after turning off.
The right joycon charges, but wont register when I slide it on.
Is there anything common in these faults? Is there anything else to blame than the Tegra? Resistors around the connectors are OK.
Continue reading...