Hi so trying to take my dead switch back alive, I can load it into hekate but have noticed the touch screen does not work all over the screen?
Basically it works around the edges but not in the middle?
Could this be down to the connection from the screen to the board?
Does anyone know which ribbon cable it is that controls touch so I can see if there are any bent pins?
Thanks
Continue reading...
Basically it works around the edges but not in the middle?
Could this be down to the connection from the screen to the board?
Does anyone know which ribbon cable it is that controls touch so I can see if there are any bent pins?
Thanks
Continue reading...