RSS Switch v1 stuck at Switch Logo after installing SX Core

  • Thread starter Thread starter mvmiranda
  • Start date Start date
M

mvmiranda

Guest
Hello!
I have a Switch v1 stuck at the Switch Logo after installing the SX Core chip.
The solder is fine but it wont pass after the logo. All it was done on the console was an emunand creation.
It could be the dreaded wifi chip failing or a corrupted NAND, right?
Is there any way I could quickly rule one of them out?
Any tip is welcome!
Thanks!

Continue reading...
 
You must log in or register to reply here.
Top Bottom