I'm currently getting error code *=* (short long short) which indicates that No eMMC block 0 read.
This does not surprise me as I was expecting an error with the EMMC.
Backstory, I started my OLED mod nearly two months ago, while doing it I was doing the Kamikaze method.
Unfortunately I was doing the install with a larger than recommended grinding bit and didn't have the neatest cut into the board.
I managed to expose the DAT 0 point while grinding and per the advice of the guide...
Read more
Continue reading...
This does not surprise me as I was expecting an error with the EMMC.
Backstory, I started my OLED mod nearly two months ago, while doing it I was doing the Kamikaze method.
Unfortunately I was doing the install with a larger than recommended grinding bit and didn't have the neatest cut into the board.
I managed to expose the DAT 0 point while grinding and per the advice of the guide...
Read more
Continue reading...