Not too sure but I seem to be stuck.
I was booting one of my other switches into cfw (sxos) using an rcm loader jig. I’m not sure if my switch died or I pulled out the on/off jig in the controller side too quickly but I cannot get the switch to do anything. It does not recognize the jig, does not get recognized in the computer and cannot get it to boot into rcm mode.
I don’t have a backup as this was my second switch. And was just trying to start to update.
Any ideas?
Continue reading...
I was booting one of my other switches into cfw (sxos) using an rcm loader jig. I’m not sure if my switch died or I pulled out the on/off jig in the controller side too quickly but I cannot get the switch to do anything. It does not recognize the jig, does not get recognized in the computer and cannot get it to boot into rcm mode.
I don’t have a backup as this was my second switch. And was just trying to start to update.
Any ideas?
Continue reading...