Hello,
When working on modding an OLED Switch, I ended up lifting part of the pad my wire was attached to (I'm using 30 gauge wire as part of an INSTINCT V6 install). I've attached a photo of the top of the resistor I soldered for the A/CMD point. I think I was using too much heat and tugged on the wire before it was properly cooled.
The resistor (4.7k 0201) is still firmly attached to the Switch motherboard, and I haven't attempted to put the console back together yet to see if it will...
Read more
Continue reading...
When working on modding an OLED Switch, I ended up lifting part of the pad my wire was attached to (I'm using 30 gauge wire as part of an INSTINCT V6 install). I've attached a photo of the top of the resistor I soldered for the A/CMD point. I think I was using too much heat and tugged on the wire before it was properly cooled.
The resistor (4.7k 0201) is still firmly attached to the Switch motherboard, and I haven't attempted to put the console back together yet to see if it will...
Read more
Continue reading...