RSS *=* Error On Switch OLED! (Can't find much info about it)

[GBATEMP]

I recently modded my switch OLED with a Picofly mod chip, and now it is throwing the error code *=* which I'm told means "No eMMC block 0 read (eMMC init failure?)". I don't exactly know what this means it seems to not be widely documented. I have already re-done the DAT0 point and made sure it was clean and all the other joints were soldered well. I am getting correct diode readings from everything as well.

Not sure where to start. Any help is appreciated!

Thanks!

Continue reading...