Hi all, long story short i broke the LCD connector on a switch, so the screen is dead. It also had the right joycon not detected in handheld mode which i fixed by replacing the rail. Now it detects the joycon. Issue is; it's not entering RCM with a printed jig I purchased on Amazon. I have Trinkets soldered in my other 2 switches so I don't have something to test the jig on but I'm assuming its good.
This is a launch console on FW 9.1 which had no issues going into RCM before the LCD...
Console not entering RCM
Continue reading...
This is a launch console on FW 9.1 which had no issues going into RCM before the LCD...
Console not entering RCM
Continue reading...