In my quest to 'consolize' a switch into a Switchn't I wanted to remove the requirement for a battery.
Not much has been done to figure this out but I did find a thread on shmups in which user fwannmacher had over time figured it out after their battery failed.
First step, there are two test points next to the battery connector (on V1 and V2 switches, yet to confirm lite or oled) that are for the Sense line and GND. Putting a 10k ohm resistor across those pads makes the...
Read more
Continue reading...
Not much has been done to figure this out but I did find a thread on shmups in which user fwannmacher had over time figured it out after their battery failed.
First step, there are two test points next to the battery connector (on V1 and V2 switches, yet to confirm lite or oled) that are for the Sense line and GND. Putting a 10k ohm resistor across those pads makes the...
Read more
Continue reading...